Sequence Of Cutting Using Stand-Off Guide - Hobart Welding Products AirForce 12ci Mode D'emploi

6-6. Sequence Of Cutting Using Stand-off Guide

EXAMPLE Of Cutting Using Stand-off Guide
1/16 in.
(1.6 mm)
Place stand-off guide on work. Stand-off
guide provides 1/16 in. (1.6 mm) gap
between tip and workpiece.
Adjust speed so
sparks go thru metal
and out bottom of cut.
.
A complete Parts List is available at www.HobartWelders.com
Split section
to bottom
Slide trigger lock back.
Press trigger. Pilot arc starts.
Pause briefly at
end of cut before
releasing trigger.
!
The pilot arc starts immediately
when trigger is pressed.
Stand-off Guide
Installation
Postflow continues for approx. 20 seconds
after releasing trigger; cutting arc can be
instantly restarted during postflow by raising
trigger lock and pressing trigger.
After cutting arc
starts, slowly
move torch
across metal.
Ref. 804 848-A / Ref. 254 087-A
OM-272180 Page 19