Section 4 − Specifications; Serial Number And Rating Label Location; Specifications For Power Source; Specifications For Torch - Hobart Welding Products AirForce 12ci Mode D'emploi

4-1. Serial Number And Rating Label Location

The serial number and rating information for this product is located on back. Use rating label to determine input power requirements and/or rated output.
For future reference, write serial number in space provided on back cover of this manual.

4-2. Specifications For Power Source

.
Do not use information in unit specifications table to determine electrical service requirements. See Section 5-5 for information on connecting input
power.
.
This equipment will deliver rated output at an ambient air temperature up to 1045F (405C).
Primary Primary Duty
Volts Amperes Cycle
120 22 (0.25*) 35%
*While idling
**10% High line condition

4-3. Specifications For Torch

Air-cooled torch for plasma arc cutting (PAC)
Gas flow/pressure: 1.1 SCFM (31.1 L/min) at 40 PSI (275 kPa)
Safety interlock devices shut down power source
Cutting capacity: see Section 4-2

4-4. Duty Cycle And Overheating

3-1/2 Minutes Cutting
Overheating
.
A complete Parts List is available at www.HobartWelders.com
SECTION 4 − SPECIFICATIONS
Individual
Branch Primary
Service Secondary
(Recommended) Volts (DC)
20A 100
6-1/2 Minutes Resting
0
Minutes
Secondary
Amperes
KW KVA
12 1.85
15
Mild Steel
Rated
Cutting Power
Capacity Factor
1/8 in. (3.2 mm)
At 10 IPM (4.2
mm/s)
2.68 0.69
1/4 in. (6.4 mm)
At 3 IPM (76
mm/min)
Duty Cycle is percentage of 10
minutes that unit can cut at rated
load without overheating.
If unit overheats, output stops.
Temperature trouble light goes On,
and cooling fan runs. Wait fifteen
minutes for unit to cool or
temperature light to go off. Reduce
duty cycle before cutting.
NOTICE − Exceeding duty cycle
can damage unit or gun and void
warranty.
duty1 4/95 − 804 852-A
OM-272180 Page 11
Max**
OCV
(DC)
375