Velleman-Kit K6703 Mode D'emploi page 18

C5 to C9 and C16, 1nF ceramic (sometimes marked as 102)
C10, 4n7 ceramic (sometimes marked as 472)
C11 to C13, 10nF ceramic (sometimes marked as 103)
C17 and C18, 100nF (sometimes marked as 104 or 100nS)
Mount the following resistors in an upright position:
R1 and R2, 47K (yellow, purple, orange)
R3 and R4, 100K (brown, black, yellow)
R5, 470 ohm (yellow, purple, brown)
R6, 270 ohm (red, purple, brown)
R7 and R8, 22K (red, red, orange)
R9, 1K (brown, black, red)
R10, 100K (brown, black, yellow)
R11, 33K (orange, orange, orange)
R12, 6K8 (blue, grey, red)
R13, 4K7 (yellow, purple, red)
R14, 2K7 (red, purple, red)
R15, 680K (blue, grey, yellow)
R16, 8K2 (grey, red, red)
R17, 82K (grey, red, orange)
R18, 1M (brown, black, green)
R19, 10K (brown, black, orange)
R20, 330 ohm (orange, orange, brown)
Mount coil L3 1 ì H (brown, black gold, silver) in an upright position
as well.
Mount LED LD2. Watch the polarity. The flat side of the LED
(cathode or shorter connection) corresponds to the side indicated
on the print.
Mount trimming capacitor CV1 (1.5 - 5pF)
Mount the electrolytic capacitors: Watch the polarity!
C14, 10 ì F
C15, 47 ì F
C19 to C21, 1 ì F
H6703-ED2-18