Dimensions - Helios AIR1-KP Notice De Montage Et D'utilisation

Installation and Operating Instructions
EN
CHAPTER 3
INSTALLATION
m
DANGER
ATTENTION
ATTENTION
NOTE
All manuals and user guides at all-guides.com
Condensate pump AIR1-KP

2.2 Dimensions

28
19
53
AIR1 XC 500, 700, 1400
3.1 Installation
The AIR1 unit must be fully isolated from the mains power supply before all mainte-
nance and installation work and opening the terminal compartment! The electrical
connections must be carried out in accordance with the wiring diagrams and must
only be carried out by qualified electricians. The electrical connection must be fully
isolated until the final assembly!
Thoroughly rinse the condensate tray to remove all metallic particles and foreign objects
before connecting the condensate pump.
The pump should never be operated "dry" without water.
1. The condensate pump installation locations are shown in the following image (the AIR1
unit has two condensate outlets for the
side (summer), see Fig.4, Fig.5.
ò
AIR1-XC L
The condensate pump is mounted for application on the
standard for AIR1-XC L (see Fig.4) or on the
If the condensate pump is used for the respective other side, the marked screws must
be loosened and the components must be reinstalled according to Fig.7.
50
73
AIR1 XC 2200, 3200
60
exhaust air side (winter) and the
ò
Fig.4
ù
AIR1-XC R
ù supply air side for AIR1-XC R (see Fig.5).
ò
Fig.6
3
28
50
19
78
ò
ù
ò exhaust air side (winter) as
ù
Fig.3
supply air
ù
Fig.5
Fig.7