NuVinci Nfinity 330 Mode D'emploi page 9

3. Nfinity assembly of components
3.1 Wheelbuilding
• The anti-shift retainer (A) provides 135mm
spacing, and should remain on the CVP
during lacing and wheelbuilding.
- Maximum spoke diameter is #13/
2.34mm
- Minimum spoke diameter is #14/
2.00mm
• Suggested lacing is a 2-cross pattern for
26 inch and 700c wheels.
-Use a 2-cross pattern only if the rim allows
the nipples to be effectively in-line with the
spokes.
• For 24 inch or smaller wheels a 1-cross
pattern is suggested.
• Radial lacing is not recommended.

Installation and repairs must be made
!
by a qualified bicycle mechanic.
 This section assumes a level of
!
knowledge and skill consistent with
that of an experienced bicycle
assembler or bicycle mechanic.
TECHNICAL OWNER MANUAL
135 mm
A
NFINITY ASSEMBLY OF COMPONENTS
EN
9