NuVinci Nfinity 330 Mode D'emploi page 15

3.7 Installing Shift Cables and Hardware
Install cable end hardware only by pulling
cables at the end of the housing (A). Never
rotate the grip (B) with cables unattached, as
they can bind inside the shifter.
1. Pass the shift cables through the
appropriate cable housing and ensure
the housing is seated completely into the
shifter.
•
Thread both barrel adjusters completely
clockwise (in) to provide maximum
installation slack.
2. Pull the underdrive shift cable (C) firmly
at the rear axle location until it stops,
checking to make sure that the shift
indicator (D) goes completely flat (Nfinity
C8 and Nfinity C8s shifters), or that the
grip rotates fully in the counter-clockwise
direction shown (Nfinity C3 shifter, viewed
from right side of bicycle).
3. Pass the underdrive shift cable through the
UD cable stop (F) and secure the UD cable
stop at the distance shown (E) while pulling
the cable firmly.
•
Ensure that the cable housing is seated fully
at the shifter.
•
Using a 2mm allen, secure the cable and
torque to 1.5-2.0 Nm (13-18 in-lbs).
TECHNICAL OWNER MANUAL
B
A
D
C
E
F
120 mm*
G
*120mm for Standard shifter and 84mm for One-Turn
4. Cut the excess cable at a maximum of
2.0mm from the end of the UD cable stop
(G).
5. Pull the overdrive shift cable (H) firmly
at the Nfinity Hub Interface until it stops,
checking to make sure that the shift
indicator (I) goes into a steep hill (Nfinity
C8 and Nfinity C8s shifters), or that the
grip rotates fully in the clockwise direction
shown (Nfinity C3 shifter, viewed from
right side of bicycle).
•
Make sure the underdrive shift cable and
UD cable stop are free and unobstructed
6. Pass the overdrive shift cable through the
OD Latch (K) and secure the OD latch at
the distance shown (J) while pulling the
cable firmly.
•
Ensure that the cable housing is seated fully
at the shifter.
•
Using a 2mm allen, secure the cable and
torque to 1.5-2.0 Nm (13-18 in-lbs).
7. Cut the excess cable at the OD latch
marking (L), and tuck the remaining cable
length into the OD latch as shown (M).
8. The cable hardware should appear as
shown. Assemble to CVP per section 2.5
and adjust cable slack with the barrel
adjusters per section 2.3.
NFINITY ASSEMBLY OF COMPONENTS
I
H
K
L
J
M
*114mm for Standard shifter and 102mm for One-Turn
15
EN