NuVinci Nfinity 330 Mode D'emploi page 13

3.5 Installing the Shifter
1. Install right brake lever according to the
manufacturer's instruction.
2. Slide the shifter (A) onto the handlebar.
3. Install the right hand grip (B) onto the
handlebar according to the manufacturer's
instructions
4. Position the shifter such that the display (C)
is visible to the rider and the cable will be
unobstructed
•
Tighten the clamp bolt to 2.0-2.5 Nm (18-
22 in-lbs).

Never use lubricants or solvents to
!
install handlebar grips.

Make sure that the shifter and the
!
brake lever function properly and are
unobstructed (re-adjust if necessary).
Never ride without the handlebar

!
grips. The turning grip of the shifter
could become loose. This can result
in a severe injury.
TECHNICAL OWNER MANUAL
A
B
C
A
B
C
NFINITY ASSEMBLY OF COMPONENTS
EN
13