Replacing The Main Filter And Active Charcoal Filter - Miele PAC 1045 Mode D'emploi

Remove the screws from the service flap on the rear of the air purifier. Remove the ser-

vice flap and the pre-filter behind it.
2.
1.
1 2
a
Pre-filter (left) with holding plate
b
Contact protection
Remove the screw in the middle (1.) and fold the contact protection forwards (2.).

Remove the screws from the holding plates of the pre-filters.

Remove the used pre-filters and place them in a sealable bag.

2
1
a
Service flap
b
Pre-filter (front)
c
Pre-filter (bottom)
Insert the new pre-filters. The flame-scarfed (coloured) side of the pre-filters must face

outwards (in the direction of the air intake vents).
Screw the holding plates of the pre-filters back into place.

Pull the contact protection downwards and screw it back into place.

Close the service flap and retighten the screws.


Replacing the main filter and active charcoal filter

Miele recommends having the main filter and the active charcoal filter replaced by the
Miele Customer Service Department.
3 4
4
5
3
en - Cleaning and care
c
Pre-filter (bottom) with holding plate
d
Pre-filter (right) with holding plate
d
Pre-filter (left)
e
Pre-filter (right)
59