Storage Support - Haussmann Xpert MSS106 Manuel De L'utilisateur

ASSEMBLY INSTRUCTIONS
Figure A3:
8. Take a Wheel (#32); one
Storage Support Connector
(#35); a M12 x 140 mm Hex
Bolt (#33); and a M12 Lock
Nut (#34).
9. Attach the Wheel to the
Storage Support Connector
by putting the Bolt through the
the M12 Lock Nut, using two
19 mm open-end wrenches.
10. Repeat to make 2 wheel
assemblies.
11. Take the completed wheel
assemblies from step 10 and
12. Use 2 M6 x 12 mm long
Phillips Truss Head Machine
Screws (#5) to attach them with
the wheels facing out, to the
2 remaining tubes, the Inside
Support Leg (#48) of the Top
Assembly.
13. Tighten with a #2 Phillips
screwdriver.
14. Press the hubcaps (
place on the wheels.
Figure A4:
15. Once the wheel assemblies are
connected, attach the Storage
Support (#37) to them with
the last 2 M6 x 12 mm long
Phillips Truss Head Machine
Screws (#5).
16. Tighten with a #2 Phillips
screwdriver.
24
MSS106
) into