Haussmann Xpert MSS106 Manuel De L'utilisateur page 23

ASSEMBLY INSTRUCTIONS
STAND BASE
Figure A1:
1. Find the Handle.
2. Find the 2 M6 x 16 mm long
Hex Head Bolts.
3. At the same end of the main
Top Assembly (
L1) as the Release Lever (see
), insert the Handle (#9)
in the 2 brackets for the handle,
located under (when upright)
the Extension Brace.
4. Use the Hex Head Bolts (#18)
and fasten the Handle to the
brackets.
5. Tighten the Bolts with a 10 mm
open-end wrench
Figure A2:
6. On the Outside Support Leg
(#6
drawing, p.27) part of the Top
Assembly, the same end of
the stand that the Handle is
now located, attach the Front
Foot using 2 of the M6 x 12
mm long Phillips Truss Head
Machine Screws.
7. Tighten the Machine Screws
with a #2 Phillips screwdriver.
23