Honeywell Prestige M28798 Guide D'installation page 10

Prestige TM Installation Guide
Link remote control to thermostat (optional)
WIRELESS SETUP
Press to link to
another thermostat
YES
CONNECT MORE?
Link outdoor sensor to thermostat (optional)
Press and release
69-2057EFS—03
CONNECT
MCR28805
Press to save
and exit
NO
1 Make sure the thermostat displays
the "Add Device" timer (see page 9).
2 Press CONNECT at the remote. There
will be a short delay as the remote
seeks a signal from the thermostat.
3 When the screen displays
"Connected," press DONE.
4 Press NO at the next screen to save
and exit. (Or press YES and repeat
steps 1-4 to link another thermostat.)
The linking procedure at the remote may time
out if there is no keypress within 30 minutes.
To begin again, press and hold the blank
space (or arrow, if present) in the lower right
corner of the screen until the display changes
(about 3 seconds).
1 Make sure the thermostat displays
the "Add Device" timer (see page 9).
2 Press the CONNECT button on the
back of the sensor.
3 Check thermostat to verify that the
outdoor sensor is working. After
about 15 seconds, the thermostat
should display outdoor temperature
and humidity.
10