Specifications; Electrical Connection; Installation - Dimplex XHD23L-INT Mode D'emploi

Specifications

General
Unpack the heater carefully and retain the packaging for possible future use, in the
event of moving or returning the fire to your supplier.
A sudden change in temperature (for example, moving the unit from frost to a
warm room) can cause condensation of moisture inside the device and disrupt its
operability when turned on.
The device, after transporting or storing at a negative temperature of outside air, must
be kept in a warm room for at least 3 hours, after which it can be put into operation."
The fire incorporates a flame effect, which can be used with or without heating, so
that the comforting effect may be enjoyed at any time of the year. Using the flame
effect on its own only requires little electricity.
Before connecting the heater check that the supply voltage is the same as that
stated on the heater.
Please note: Used in an environment where background noise is very low, it may be
possible to hear a sound which is related to the operation of the flame effect. This is
normal and should not be a cause for concern.

Electrical Connection

WARNING: THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the voltage marked on the
heater must correspond to the supply voltage.
Before switching on, please read the safety warnings and operating instructions.
6

Installation

Placement
1.
The Dimplex Electric Fireplace does
not require any special venting.
Make sure there is clearance for air
circulation beneath the unit and at
least 1/2" behind it.
CAUTION: Do not install the fireplace
directly on carpet or similar surfaces which
may restrict air flow.
2.
Install the unit in an opening with the
following minimum dimensions:
Model XHD28
A 27" (686 mm) wide
B 31-1/8" (587 mm) high
C 8" (203 mm) deep
Model XHD26
A 24-3/8" (619 mm) wide
B 18-1/2" (470 mm) high
C 8" (203 mm) deep
Model XHD23
A 21-1/2" (548 mm) wide
B 20" (508 mm) high
C 8" (203 mm) deep
3.
If installing the unit in an existing
fireplace opening, seal all drafts
and vents with a non-fibrous
insulation material to prevent any
chimney debris from falling onto
the unit. Do not install into an
existing fireplace opening that is
prone to dampness.
C
A
B
7