Leak Testing Instructions - Napoleon TQ240 Manuel D'utilisation

Table Top Use
This unit has been designed with mobility in mind. With collapsible legs, this portable grill can be set up
on most tabletops. The legs fold out and lock into place, folding back into a locked position when on the
go.
!
WARNING!
WARNING!

Leak Testing Instructions

!
WARNING!
part of the gas system is replaced.
WARNING!
!
are in the area while you check for leaks. Sparks or open flames will result in a fire or explosion,
damage to property, serious bodily injury, or death.
Leak testing: This must be done before initial use, annually, and whenever any gas components are
replaced or serviced. Do not smoke while performing this test, and remove all sources of ignition. See Leak
Testing Diagram for areas to check. Turn all burner controls to the off position.
or slowly turn on the gas supply valve (large propane cylinder)
Brush a half-and-half solution of liquid soap and water onto all joints and connections of the regulator,
hose, manifolds and valves.
Bubbles will indicate a gas leak. Either tighten the loose joint or have the part replaced with one
recommended by the Napoleon Customer Solutions department and have the grill inspected by a certified
gas installer.
STOP
If the leak cannot be stopped, immediately shut off the gas supply, disconnect it, and have the grill
inspected by a certified gas installer or dealer. Do not use the grill until the leak has been corrected.
The legs located on each side of your grill must be unfolded during use.
Do not use the grill on plastic, resin or glass table tops.
A leak test must be performed annually and each time a cylinder is hooked up or if a
Never use an open flame to check for gas leaks. Be certain no sparks or open flames
7
Connect a disposable cylinder
X
www.napoleon.com
EN