Exterior Ceiling Mounting - Axis 231D Guide D'installation

Page 6

Exterior Ceiling Mounting

Control
button
Network
connector
Connection
module
connector
Power
Indicator
Network
Indicator
Follow these instructions to mount the dome camera:
1. Using the supplied drill template, drill three holes in the ceiling and secure the bracket to
the ceiling with three screws.
2. Connect the connection module cable to the
connection module.
3. Connect the Ethernet cable and connection module
to the AXIS 231D/232D.
4. Connect the power cable (24V AC) to the
connection module and check that the power and
network LEDs light up green.
5. Mount the dome body onto the bracket and rotate
it clockwise. Make sure the screw hole on the side
of dome is aligned with the bracket. Tighten the
fixing screw to secure the dome.
6. Attach and secure the decoration ring to the bracket.
7. The hardware installation is now complete, proceed to Setting the IP address, on page 8
to install the AXIS 231D/232D on your network.
AXIS 231D/232D Installation Guide
Decoration
ring
Serial number
S/N
Mounting slot for
fixing screw
PS GND not used
24V AC
Connection module cable connector