Installing The Fan With A Downrod Configuration - Hinkley 56 GROVE Manuel Du Propriétaire

INSTALLING THE FAN WITH A DOWNROD CONFIGURATION

Remove ball from downrod by loosening set screw in the
1
side of the ball. Slide ball down and remove ball pin;
remove ball. (Fig. 1)
Carefully support fan body (motor) in its styrofoam packing
2
with the mounting collar (where the wires come out) facing
upward.
Loosen the two set screws and remove the hitch pin and
3
retaining clip from the coupling on top of the motor
assembly. (Fig. 2)
Carefully feed the electrical lead wires from the fan up
4
through the downrod. Insert downrod pin through holes in
mounting collar and downrod; slip cotter pin through small
hole in end of downrod pin to hold downrod in place.
Tighten security screws against downrod using a large flat
5
blade screwdriver to ensure a tight fit against downrod.
Tighten nuts against mounting collar.
06 | hinkley.com
Cross pin
Hanger
ball
Set screw
Fig. 1
Hook-up
(3) Wires
Downrod
Mounting Collar
Cotter Pin
Top of
Fan Body
Fig. 2
Downrod
Safety Cable
Security Screws
Downrod Pin