Transport And Handling - Whirlpool AWZ9CD/PRO Consignes D'installation, D'utilisation Et De Sécurité

Below is a summary of possible failure causes and
solutions .
If the problem persists after having followed the
instructions as indicated below, press and hold
On/Off for at least three seconds . If afterwards the
failure indication still appears, switch off and unplug
the dryer and contact our After-Sales Service .
Display message Possible Cause
F01 to F04
Failure of a component
F05 to F09
Failure of a component
F10 to F24 Failure of a component

TRANSPORT AND HANDLING

WARNING
1.
Unplug the dryer .
2.
Make sure that door and water tank are
properly closed .
All manuals and user guides at all-guides.com
Solution
Press and hold On/Off for at least 3 seconds .
Switch off and unplug the dryer . Immediately
open the door and take out the laundry, so that
the heat can dissipate.
Make sure that the ambient temperature ranges
between 5°C and 35°C . Wait for about an hour .
Plug in the dryer, load the laundry and start the
programme again .
If the failure persists, call the After-Sales Service .
Switch off and unplug the dryer . Wait for about half
an hour . Plug in the dryer and start the programme
again .
If the failure persists, call the After-Sales Service .
Never lift the dryer by
holding it at the worktop.
3.
system, fix the drain hose on the rear of the dryer
again (see Installation Guide) .
If the drain hose is connected to your sewage
EN
131