The Lcd Screen Will Indicate 'Brewing', However; There May Be A Short Pause Before The Brewing; Process Begins. The Process Lasts About 60; Seconds And Ends With A Burst Of Air To Remove - Breville BKC600XL Mode D'emploi

BR9013 BKC600XL_IB_AMEND.qxp
Operating your Breville Gourmet Single Cup Brewer
a. The LCD screen will indicate the default brew
size (7.25 oz.). To choose a different size, press
the to go up in size or the
down in size.
Select from a stronger small cup (5.25 oz. serving),
a small mug (7.25 oz. serving), a large mug (9.25
oz. serving) or a travel mug (11.25 oz. serving).
The small mug (7.25 oz. serving) is the default
brew size. To program your favorite brew size,
refer to Setting the 'BREW SIZE' feature (page 20).
b. Once the brew size is selected, press the 'BREW'
Button. The 'BREW' button will stop flashing, the
and buttons will no longer be lit. The
LCD screen will indicate 'BREWING' and the
selected brew size.
If the 'BREW' button is not pressed in 60

seconds, the LCD screen will indicate 'OPEN

HEAD' and the 'BREW' button will be disabled to
prevent accidental activation. To re-activate the
brew sequence, open the Brewing Chamber

Head by raising and lowering the Safety Locking

Arm completely.

14
11/10/07 21:43 Page 14

12. The LCD screen will indicate 'BREWING', however

there may be a short pause before the brewing

button to go

process begins. The process lasts about 60

seconds and ends with a burst of air to remove

all liquid from the My K-Cup ® Holder.
There is extremely hot water in the My K-Cup ®
Holder during the brewing process. To avoid risk
of injury, do not raise the Safety Locking Arm or
open the Brewing Chamber during the brewing
process.

Following the brew, the LCD screen will indicate

Note

'HEATING' as the Brewer heats the water for the

next brew cycle. This process lasts about 15

seconds. The pump will make a vibrating sound.

This is normal.

13. Raise the Safety Locking Arm, remove the
assembled My K-Cup ® Holder. Use caution as
the My K-Cup ® Holder will be hot.
14. Disassemble the My K-Cup ® Holder by removing
the Lid from the Holder in a counter-clockwise
direction. Remove the Filter Basket from the
Holder, discard the grounds and rinse out the
Filter Basket and Holder.

15. Enjoy your first cup of gourmet coffee, tea or

hot cocoa!

Note
™
continued
The My
ground
a) Use a
b) Use t
After bre
the K-Cu
Brewing
To replac
Locking
Insert K-
aligning
with the
Use caut
needle o
Note
Head tha
Stopping
To stop bre
and releas
Brewer to
hot cocoa
and the LE
longer be
'ON-OFF T
panel butto
back on.
You may
your nex
recomm
Brewing
then dis
the brew
K-Cu
K-Cu