Installation And Operation; Safety Instructions; Installation And Connection; Operation - Bartscher SNACK Mode D'emploi

5. Installation and operation

5.1 Safety instructions

WARNING! Electrical hazard!
Connect the device to a properly installed and grounded single power socket.
Never yank cord to disconnect from outlet. Cable must not touch any hot parts.
See that the cable does not touch any heat sources or sharp edges. Do not let the cable
o
dangle over the counter edge.
WARNING! Danger of burn!
During operation some parts of the device become very hot. In order to avoid injuries do
not touch any hot parts!
o Do not use the device in case it does not function properly, has been damaged or dropped.
Do not use any accessory or spare parts that have not been recommended by the manufacturer.
o
These can be dangerous for the user or lead to damages of the device or personal injury, and
further, the warranty expires.
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep away the
o
cable from operating range and do not dunk it into water.
Do not move or tilt the device when in operation.
o
o During operation of the unit your hands, the mains plug must be dry.
o Do not leave the unit unattended during operation since there might occur malfunctions which
could result in overheating of the oil (fat). In case of high temperatures oil (fat) might ignite.
You may not use moisten frying goods. Always remove the extra ice from deep frozen goods
o
first. Even the smallest water drops may cause oil splashes or lead to explosions during frying.
Do not leave any frying goods in the basket hanging over the container with the hot oil.
o
o The fryer may not be moved or repositioned as long as the oil is hot.
WARNING! Risk of injury!
Hot oil splashes and fat explosions respectively may cause burns at hands and face!
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation! Before installation the local
power grid specification should be compared with that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!

5.2 Installation and connection

ATTENTION!
The device may be installed by a qualified specialist only.
•
Discard the complete packing material after unpacking the device.
- 18 -
All manuals and user guides at all-guides.com
The oil must cool down first.