Hama MW1002 Mode D'emploi page 41

NOTE
► If the device does not detect a breath sample within
5 seconds after the countdown is complete, it beeps
for an additional 10 seconds. In order to perform
the alcohol test, you must press the SET button [8]
while blowing into the device.
► If the device still does not detect a breath sample,
ERROR [15] and ERR appear in the display (1) and
the device beeps several times. Restart the alcohol
test by pressing the SET button [8] or by sliding the
faceplate down and back up again.
The device automatically initiates the cleaning process after
each test.
u Press the SET button [8] if you wish to perform another
test.
u Remove the plastic tube from the mouth piece and slide
the faceplate downwards in order to end the alcohol
test.
u Clean the used plastic tube.
MW-1002
All manuals and user guides at all-guides.com
GB
41