General Operations; Turning The Power On/Off; Setting The Clock - Bosch BLAUPUNKT KEY LARGO DM2000 Mode D'emploi

11
DISC SELECT button
Select the desired CD in CDC (CD changer) mode.
12
SC/PS button
Scan tuning. Preset scan tuning. Scan play in CD/CDC
mode.
13
AUD button
Audio control selector; Bass, Treble, Loudness, Balance
& Fader.
14
Dial
Adjusts the volume level/bass/treble/balance/fader.
Storing the station names. Select Alfa-numeric charac-
ters.
15
Infrared Sensor (behind acrylic facia)
Permits wireless remote control of AM/FM/CD and CD
changer with optional Credit Card Style. See Dealer for
Details.
Key Largo (Eng) p.1-13

General Operations

Turning the power On/Off

Press the to turn on or off the unit.
PWR
Tip
When you turn on the unit, "HELLO" will be displayed then
"WELCOME" will momentarily be displayed before actual
power on.
When you turn off the unit, "SEE YOU" will be displayed then
"GOOD-BYE" will momentarily be displayed before actual
power off.
You can edit these message. (See "Turn on/off message
edit")
Volume Level Control and Memory
Rotate the dial to adjust the volume.
It is also possible to set the maximum volume for when the
power is switched on by following the procedure explained
below.
1.
Turn the dial until it is set at the required volume.
Volume down
Volume up
2.
Press the
PWR
be switched off and the current volume level recorded.
Muting the sound
Press .
MUTE / SENS
" MUTE " appears on the display window.
To restore the previous volume level, press
3
for two or more seconds. The power will
again.
MUTE / SENS
6/19/00, 10:02 AM

Setting the Clock

The clock uses a 12-hour display system. (factory set)
1.
Turn the ignition key to the ON position.
2.
Press the to turn on the unit.
PWR
3.
Repeatedly press the to display " CLOCK 12 ".
DISP
4.
Rotate the dial within 5 seconds to select the 12 or 24-
hour time mode. Each time you rotate the dial, the mode
changes or toggles as follows :
CLOCK 24
CLOCK 12
5.
Repeatedly press the to display " CLK ADJ ".
DISP
A. Press the within 5 seconds to flash the hour digit.
MUTE / SENS
B. Rotate the dial to set the hour digit.
C. Press the to flash the minute digit.
MUTE / SENS
D. Rotate the dial to set the minute digit.
6.
Press the momentarily to complete the Clock set-
DISP
ting mode.
Note
If you make no button input or dial operation in 20 seconds,
the Clock setting mode will turn off automatically.
Ignition-off Clock Recall
The display will illuminate showing the time and then auto-
matically shut off after 5 seconds.
Press the while the ignition switch is in the " OFF " posi-
DISP
tion.
E-3