Initial Operation - Cresta DTX 370 Mode D'emploi

Initial Operation

•
Open the battery compartment located on the rear side of the devices. Place the batteries in
the battery compartment. Observe the shown polarity.
• The altitude flashing , pls use "    ", "    "to set the altitude of your position, then press
"HISTORY", weather symbol flashing, pls use " ", "" to choose the weather .
•
The station is now connecting to the outdoor sensor. This process takes about 3 minutes.
Then the display shows the outdoor temperature and humidity, in case of failure of reception ,
pls press"CHANNEL"for more than 3 seconds to receive again.
•
the automatic receiving of the DCF radio signal begins after 3 minutes of outdoor reception.
•
This RCC reception process is going on,the flashing symbol "radio tower" appears in the time
display area at the same time.
•
Once radio signal receiving is successful, the display shows the symbol "radio
tower" continuously.no flashing.
If, due to bad reception,or no RCC automatic time reception is possible, follow the steps below
manually.
Manual time set-up (the most important is to quit the receiption of radio
controlled signal by holding together "+ "and -
the radio tower symbol flashing before set-up )
•
Press and hold key "MODE" for 3 seconds.
•
The display for the year is flashing. Use " " and "" to select the year.
•
Press "MODE " to confirm.
•
The display for the month is flashing. Use " " and "" to select the month.
•
Press "MODE " to confirm.
•
The display for the date is flashing. Use " " and "" to select the date.
•
Press "MODE " to confirm.
•
The display for the time zone is flashing. Use " " und "" to select the time zone
(-12 to +12).
•
Press "MODE " to confirm.
•
The language selection for the display of the weekdays is flashing. Use " " and " " to select
the language.
•
Press "MODE " to confirm.
•
The 12/24 hour flashing. Use " " and " " to select
•
Press "MODE " to confirm
•
The display for the hour is flashing. Use " " and "" to select the hour.
•
Press "MODE " to confirm.
•
The display for the minutes is flashing. Use " " and "" to select the minutes.
•
Press "MODE " to confirm.
for 3 seconds in case of
34