Bosch GSH 388 Professional Instructions D'emploi page 8

All manuals and user guides at all-guides.com
OBJ_BUCH-288-001.book Page 8 Friday, February 23, 2007 10:25 AM
Technical Data
Demolition Hammer
Article number
Rated power input
Impact rate
Impact energy per stroke at output/rated power
Chisel positions
Chiselling capacity in concrete of medium hardness
Tool holder
Lubrication
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltages and models for specific countries, these
values can vary.
Please observe the article number on the type plate of your power tool. The trade names of individual tools may vary.
Product Features
The numbering of the product features refers to the
illustration of the power tool on the graphics page.
1 Dust protection cap
2 Locking sleeve
3 Chisel adjustment ring (Vario-Lock)
4 Lock-on button for On/Off switch
5 On/Off switch
6 Auxiliary handle
Illustrated or described accessories are not included as
standard delivery.
Assembly
Auxiliary Handle
Operate your power tool only with the auxil-
iary handle 6.
The auxiliary handle 6 can be set to any position for a
secure and low-fatigue working posture.
Turn the bottom part of the auxiliary handle 6 in coun-
terclockwise direction and swivel the auxiliary handle 6
to the desired position. Then retighten the bottom part
of the auxiliary handle 6 by turning in clockwise direc-
tion.
8 | English
GSH 388
Professional
0 611 388 0..
W 1050
bpm 2800
J 10/8
12
kg/h 180
SDS-max
Oil lubrication
kg 4.9
/II
Changing the Tool
Before any work on the power tool itself, pull
the mains plug.
With the SDS-max tool holder, simpler and easier tool
changing is possible without additional aids.
The dust protection cap 1 largely prevents the entry of
drilling dust into the tool holder during operation. When
inserting the tool, take care that the dust protection
cap 1 is not damaged.
A damaged dust protection cap should be
changed immediately. We recommend having
this carried out by an after-sales service.
Inserting (see figure A)
Clean and lightly grease the shank end of the tool.
Push back the locking sleeve 2 and insert the tool in a
twisting manner into the tool holder. Release the lock-
ing sleeve 2 again in order to lock the tool.
Check the latching by pulling the tool.
Removing (see figure B)
Push back the locking sleeve 2 and remove the tool.
GSH 388 X
Professional
0 611 388 9..
1050
2800
10/8
12
180
Hexagonal 17 mm
Oil lubrication
4.9
/II
1 619 929 785 • 23.2.07