Troubleshooting; Hints On Disposal - Klarstein MUNDSCHENK 3XL Mode D'emploi

EN
26

TROUBLESHOOTING

Problem
Ingredients stuck in the
pump.
Failing to reach 100 °C.
Temperature correction.
ERR-1 shown on display.
ERR-2 shown on display.
During the heating
process, the device
suddenly goes off.

HINTS ON DISPOSAL

If there is a legal regulation for the disposal of electrical
and electronic devices in your country, this symbol on the
product or on the packaging indicates that this product must
not be disposed of with household waste. Instead, it must be
taken to a collection point for the recycling of electrical and
electronic equipment. By disposing of it in accordance with
the rules, you are protecting the environment and the health of
your fellow human beings from negative consequences. For
information about the recycling and disposal of this product,
please contact your local authority or your household waste
disposal service.
Possible cause and suggested solution
Flush the pump by connecting a hose to the curve pipe.
Dismantle the pump to remove the ingredients.
Put lid on for 1 to 2 mins.
Do temperature correction.
Do temperature correction. Press „-" and „+" at the
same time enter into C1 temperature correction setting.
Setting range is from -10°C to +10°C (or -50 °F. to
+50 °F, respectively). Press Temp button to confirm the
setting and exit the temperature correction page
Temperature is lower than -20 °C, low temperature
warning.
Possible sensor failure. Please contact Customer Service.
Temperature is higher than 120 °C, overheat/boil-dry
warning.
Sensor failure, please contact dealer for replacement.
Reduce the heating temperature.