LG OLED55G2 Serie Manuel D'utilisation page 12

Running [Pixel Cleaning] to Protect the
OLED TV Screen
The OLED TV is equipped with a pixel cleaning feature to check the status of
the screen by itself and prevent image retention that leaves an image on a
screen. This feature automatically calculates the optimal execution time based
on the accumulated viewing time and is automatically executed when the
TV is turned off. While this feature is running, horizontal lines may appear at
the top and bottom of the screen. The pixel cleaning feature works when the
product is connected to the power cord and main power.
• To run this function manually, press the
→ [General] → [OLED Care] → [OLED Panel Care]
control, go to
and press [Pixel Cleaning].
Recommendations for Minimising
Image Retention
When watching the TV for a long time, press the
WARNING! (STABILITY HAZARD)
A television set may fall, causing serious personal injury or death. Many
injuries, particularly to children, can be avoided by taking simple precautions
such as:
- ALWAYS use cabinets or stands or mounting methods recommended
by the manufacturer of the television set.
- ALWAYS use furniture that can safely support the television set.
- ALWAYS ensure the television set is not overhanging the edge of the
supporting furniture.
- ALWAYS educate children about the dangers of climbing on furniture
to reach the television set or its controls.
- ALWAYS route cords and cables connected to your television so they
cannot be tripped over, pulled or grabbed.
- NEVER place a television set in an unstable location.
- NEVER place the television set on tall furniture (for example,
cupboards or bookcases) without anchoring both the furniture and the
television set to a suitable support.
- NEVER place the television set on cloth or other materials that may be
located between the television set and supporting furniture.
- NEVER place items that might tempt children to climb, such as toys
and remote controls, on the top of the television or furniture on which
the television is placed.
If the existing television set is going to be retained and relocated, the same
considerations as above should be applied.
Symbols
Refers to alternating current (AC).
Refers to direct current (DC).
Refers to class II equipment.
Refers to stand-by.
Refers to "ON" (power).
Refers to dangerous voltage.
12
button on the remote
button on the remote
Regulatory
→ [Picture] → [Select Mode] and set the mode to [Eco]
control, go to
/ [APS] (Depending on country), go to [Advanced Settings] → [Brightness]
and set [OLED Pixel Brightness] to a lower level. In addition, press the
button on the remote control, go to
[OLED Panel Care] and set the [Adjust Logo Brightness] value to [High].
When showing images with black bars at the top/bottom/left/right side of
the screen, press the button on the remote control, press
[Picture] → [Aspect Ratio] → [User Selection] → [Vertical Zoom] or [4-Way
Zoom] to remove the black bars.
Turn off the menus for setting up devices such as set-top boxes so that they
are not displayed on the screen for a long time.
Note
• When the screen is showing one fixed image for a long time, the screen
brightness will be automatically reduced and then restored once the
screen content changes. This is a normal function to minimise image
retention.
(Only Jordan)
WEEE
0197
Disposal of your appliance
The symbol indicating separate collection for
electrical and electronic equipment consists of the
crossed-out wheeled bin.
0197
→ [General] → [OLED Care] →
, and go to