V-TAC 80133970 Instructions De Montage page 7

TIP: First, connect power to the device, then the device will sound "Camera start
-> wait for connection" then you can start to operate on APP to start adding
device. If you do not hear "wait for connection", press the "RESET" button in the
device to reset and try again.
Add Camera
Add camera Tap on top right corner "+" sign as shown below (figure 7)
•
Tap on "Intelligent Camera" as shown below(Figure 8)
•
There are three ways for adding the camera: (a) Device adding by scanning
•
code (b) Addition of AP hotspot (c) Addition by connecting to network cable(This
feature is not available for this camera) (Refer to Figure 9)
FIGURE 7
ADDING CAMERA DEVICE TO THE APP
FIGURE 8
ENGLISH
FIGURE 9