Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PREPARING THE INSTALLATION OF THE PANEL HEATER
Installation guidelines
- This device was designed to be installed in residential premises. In any other case, please call your
distributor.
- Installation must comply with the standards currently enforced in the country of use.
- The panel heater must be supplied with 230V single-phase 50Hz.
- In damp areas such as bathrooms and kitchens, you must install the connection box at least 25cm
above the floor.
Keep the panel heater away from any draughts that may interfere with its operation
(e.g.: under a centrally controlled fan, etc ...).
Do not install the heater under a fixed socket.
The panel heater is fitted with a detection system, whose sensor is located on the front of the
appliance.
Comply with the minimum distances from
any furniture units when positioning the
appliance.
We strongly advise against installing vertical machines above an altitude of 1000m
(risk of faulty operation).
All manuals and user guides at all-guides.com
Installation
Installing a machine at altitude causes an increase in air output temperature
(of the order of 10°C per 1000m above sea level).
It is forbidden to install a vertical machine horizontally or vice versa.
Do not use the device in mobile, on feets or on casters.
Volume 1 No electrical appliance
Volume 2 Class II IPX24 electrical appliance
Volume 3 Class II electrical appliance
To optimise absence detection by your appliance, do not
install it in a closed off corner or behind furniture.
30
50 cm
Publicité
Table des Matières
