General Information; Key Of Symbols; Qualified Staff; Improper Use - Madas M16/RMO N.A. Mode D'emploi

Électrovanne a réarmement manuel normalement ouvert pour gaz
Masquer les pouces Voir aussi pour M16/RMO N.A.:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.0 - GENERAL INFORMATION

This manual shows you how to safely install, operate and use the device.
The instructions for use ALWAYS need to be available in the facility where the device is installed.
ATTENTION: installation/wiring/maintenance need to be carried out by qualified staff (as explained
in section 1.3) using appropriate personal protective equipment (PPE).
For any information pertaining to installation/wiring/maintenance or in any case problems that cannot be resolved with the use
of the instructions, it is possible to contact the manufacturer from the address and phone numbers provided on the last page.
1.1 - DESCRIPTION
Normally open, manual reset solenoid valves for gas, suitable to shut-off gas and signal danger sent by gas detectors (methane,
LPG, carbon monoxide and similar), safety thermostats, etc.
They can only be reset manually and only when they are not electrically powered.
They are fitted with a VPI (Visual Position Indicator) for visual indication of the valve obturator's position. When the valve is
closed, the red band, which is usually hidden by the reset knob (1), is visible.
M16/RMOC N.A. versions are equipped with a push button (13) that allows to close manually the gas substituting the manual
tap of the gas line allowing also to test at intervals the good working of the solenoid valve.

1.2 - KEY OF SYMBOLS

DANGER: In the event
of inobservance, may
be caused damages to
tangible goods.

1.3 - QUALIFIED STAFF

These are people who:
• Are familiar with product installation, assembly, start-up and maintenance;
• Know the regulations in force in the region or country pertaining to installation and safety;
• Are trained in first aid.
1.4 - USING NON-ORIGINAL SPARE PARTS
• To perform maintenance or change parts (ex. coil, connector, etc.) ONLY manufacturer-recommended parts can be used.
Using different parts not only voids the product warranty, it could compromise correct device operation.
• The manufacturer is not liable for malfunctions caused by unauthorised tampering or use of non-original parts.

1.5 - IMPROPER USE

• The product must only be used for the purpose it was built for.
• It is not allowed to use different fluids than those expressly stated.
• The technical data set forth on the rating plate must not be exceeded whatsoever. The end user or installer is in charge of
implementing proper systems to protect the device, which prevent exceeding the maximum pressure indicated on the plate.
• The manufacturer is not responsible for any damage caused by improper use of the device.
Madas Technical Manual - 3|3.1a - REV. 0 of 10
DANGER:
In
inobservance, may be caused damages
to tangible goods, to people and/or pets.
9
Oct 2018
th
the
event
of
M16/RMO N.A. - M16/RMOC N.A. - MBA/RMO N.A.
ATTENTION: Attention
is drawn to the technical
details
intended
for
qualified staff.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

M16/rmoc n.a.Mba/rmo n.a.

Table des Matières