Cleaning; Storage - iTronics IR8000 Mode D'emploi

DANGER by ultrasonic waves!
Do not touch the inside of the stainless steel tank or the cleaning fluid during
EN
the cleaning process: ultrasonic waves may cause injury to health.
WARNING! Risk of material damage!
Never use the device without water, since this may damage it.
Once you have used the device five times in a row, stop the cleaning process
and leave it to cool to room temperature.
An extended cleaning period and repeated cleaning may cause loosely fastened
fittings, labels or decoration at objects as well as other parts, which are not fixed
such as screws of eyeglass frames, to come off during the cleaning process.
Adding dishwashing detergent may cause the removal/dissolution of labels
and adhesives.
1. Open the lid 4.
2. Fill the stainless steel tank 2 with cleaning fluid. The cleaning fluid must cover
the parts to be cleaned. However, the maximum filling level MAX 1 must not even
be exceeded with the object in place. A suitable cleaning fluid is usually cold,
clean tap water. The cleaning effect can be intensified by adding dishwashing
detergent (please observe manufacturer's information). Do not use corrosive
cleaning agents, ammonia, bleach or strongly perfumed cleaning agents.
3. Place the objects to be cleaned in the ultrasonic cleaner. Use the insets.
4. Close lid 4.
5. The device is switched on when the mains plug is connected. Connect the mains
plug 5 with a wall socket. The display 6 shows 180.
6. Press the button SET 8 repeatedly until the requested cleaning period appears
on the display (180, 300, 480, 600, 090 seconds) - depending on the degree of
staining.
090 seconds: recommended for minor staining and objects such as eyeglasses.
180 seconds: standard time for normal staining.
300 seconds: recommended for the initial cleaning with the ultrasonic cleaner.
480 seconds: recommended for the initial cleaning if several objects are cleaned
simultaneously.
600 seconds: recommended for severe staining.
7. Press the button START 9 to start the cleaning process. The power LED 3 is lit
blue and the seconds are counted down on the display. During the cleaning
process, a buzzing / humming can be heard.
-10-
8. After the requested cleaning period has elapsed, the power LED 3 goes off and
the display shows 000. By pressing the button STOP 7, you are able to interrupt
the cleaning process earlier at any time.
Press ...
... the button START 9, to continue with the cleaning process for the remaining
cleaning period.
... the button SET 8, to set the requested cleaning period and start the cleaning
process by pressing the button START 9.
9. The device is switched off when the mains plug is disconnected. The display
goes off.
10. Open the lid 4 and remove the cleaned objects.
11. Dry the cleaned objects with a soft cloth and repolish shiny surfaces, if necessary.
12. Drain the cleaning fluid.
NOTE: if necessary after the cleaning process, change the cleaning fluid to
achieve a more thorough clean.

7. Cleaning

DANGER of electric shock!
Pull the mains plug out of the wall socket before you clean the device.
WARNING! Risk of material damage!
Do not use any astringent or abrasive cleaning agents.
Ultrasonic device
Drain the cleaning fluid after each cleaning process.
In order to prevent lime residues and soiled rims, wipe the stainless steel tank
and the outer surface of the device with a soft, slightly damp cloth.
Accessories
Clean the insets with a soft, slightly damp cloth.

8. Storage

DANGER for children!
Keep the ultrasonic cleaner out of the reach of children.
Allow the device to cool down before you put it away.
Clean and dry all parts, before putting the device away.
-11-
EN