Items Supplied; How To Use; Operation; Describing The Functioning Of The Ultrasonic Cleaning Process - iTronics IR8000 Mode D'emploi

If liquids enter the inside of the device, pull the mains plug immediately. Have
the device checked before reusing.
Never touch the device and mains plug with wet hands.
EN
The stainless steel tank must not be filled with water above the MAX marking,
otherwise it may overflow during the cleaning process.
DANGER of electric shock
Do not use the device if the device or the power cable has any visible damage,
or if the device has previously been dropped.
Only connect the mains plug to a properly installed and easily accessible wall
socket whose voltage corresponds to the specifications on the rating label. The
wall socket must continue to be easily accessible after the device is plugged in.
Ensure that the power cable cannot be damaged by sharp edges or hot points.
Do not wrap the power cable around the device.
When using the device, ensure that the power cable cannot be trapped or
crushed.
When removing the mains plug, always pull the plug and never the cable.
Disconnect the mains plug from the wall socket...
... if there is a fault,
... when you are not using the device,
... before you clean the device, and
... during thunderstorms.
If the mains power cable of this device should become damaged, it must be
replaced by the manufacturer, the manufacturer's customer service department
or a similarly qualified specialist, in order to avoid any hazards.
This device is not intended to be operated using an external timer clock or a
separate remote control system.
DANGER by ultrasonic waves
Do not touch the inside of the stainless steel tank or the cleaning fluid during
the cleaning process: Ultrasonic waves may cause injury to health.
WARNING! Risk of material damage!
Always use the basket inset for small parts to prevent scratches on the parts
and the stainless steel tank. If several parts are located in the cleaning fluid
during the cleaning process, these must not be in contact to prevent scratches!
-6-
Do not clean objects whose surfaces show scratches, since these scratches
may deepen during the ultrasonic treatment.
Do not use corrosive cleaning agents, ammonia, bleach or strongly perfumed
cleaning agents for cleaning in this device.
The device is fitted with non-slip silicon feet. Because furniture can be coated
with a wide variety of varnishes and plastics, and treated with various care
products, the possibility cannot be excluded that some of these substances
have ingredients that may attack and soften the silicon feet. If necessary,
place a non-slip mat under the device.
Once you have used the device five times in a row, stop the cleaning process
and leave it to cool to room temperature.
Never use the device without water, this may damage the device.
Place the device on a stable, flat surface.
Do not place the device and its accessories on or near surfaces, which are or
may become hot, e. g. heating panels.
Only use the original accessories.
Do not use corrosive or abrasive cleaners to clean the device.

4. Items supplied

1 ultrasonic cleaner
1 basket inset 11
1 bracelet holder 10
1 spindle with spacer ring 12
1 set of operating instructions

5. How to use

Remove all packing material.
Remove the protective foil from the display 6.
Check to ensure that all accessories and the device are undamaged.
Place the device on a stable, flat surface.

6. Operation

6.1 Describing the functioning of the ultrasonic cleaning process

The ultrasonic field building up in the cleaning fluid during the operation generates
waves with a positive and negative pressure in quick succession. On the surface
-7-
EN