Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 3 Ø6 rubber washers
Assembly
- Remove the original chain guard and the rear brake hose fixing bracket. To make it easier, remove
the exhaust system.
- Position the rear hugger on the swinging arm.
- Position the two screws and washers on left hand side without tightening completely.
- On the right hand side, position the rear hugger above the fitting of the rear brake hose fitting
without completely tightening the screw and washer.
- Align the hugger with the tyre by making it slide forwards and backwards.
- Finish tightening the three screws.
- Reposition the exhaust system.
- Don't forget to harden the rear shock absorber when you ride with a passenger or on poor road
surfaces to avoid damaging the rear fender.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with original
tyres and whose dimensions correspond to these ones engraved on tyre.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
ADAPTABLE SUR GSX R 600 2001/2003
« CAUTION »
FITTING INSTRUCTIONS
ERMAX REAR HUGGER
Original tyre 180/55 ZR 17.
Publicité
