Attach The Auxiliary Handle; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks Pro STB402 Manuel De L'utilisateur

WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
8.2 ATTACH THE AUXILIARY
HANDLE
1. Remove the screws (1) from the handle with a Phillips
screwdriver (not provided).
2. Attach the auxiliary handle (2) and lower clamp (3) on
the shaft.
3. Set the auxiliary handle in the most comfortable in use
position.
4. Tighten the screws.
1
2
3
English
8.3

INSTALL THE BATTERY PACK

• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
1
8.4

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (1).
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

CONTROLS

9.2

START THE MACHINE

1. Pull back on the lock-out button (1) and pull the trigger
(2). Once the machine is running you can release the
lock-out button.
9.3

STOP THE MACHINE

1. Release the trigger to stop the machine.
7
WARNING

IMPORTANT

WARNING
1
2
EN