Table Des Matières - AEMC Instruments 6240 Notice De Fonctionnement

1. INtRODUctION.................................................................................................................................... 3
1.1. Pistol test probe ....................................................................................................................... 4
1.2. SPRING LOADED Test probe ................................................................................................... 5
2. USE ........................................................................................................................................................ 6
3. SPEcIFIcAtIONS .................................................................................................................................. 7
3.1. Environmental conditions ........................................................................................................ 7
3.2. MECHANICAL SPECIFICATIONS ............................................................................................ 7
3.3. Electrical safety ........................................................................................................................ 7
4. MAINtENANcE ..................................................................................................................................... 8
4.1. Cleaning .................................................................................................................................... 8
4.2. Repair ....................................................................................................................................... 8
5. WARRANty .......................................................................................................................................... 8
6. tO ORDER ............................................................................................................................................. 8
the straight and pistol-grip spring loaded 10a test probes can be used to measure a low resistance
very accurately with micro-ohmmeters that have binding posts from 4mm to 6mm in diameter or safety
terminals 4mm in diameter.
„ the pistol-grip spring loaded test probes ensure a good contact at the measurement point even if the
surface is uneven.
„ the straight spring loaded test probes can, in addition, improve the contact by removing a thin layer of
rust, paint, or dirt. When the user presses on the probes, they rotate as they retract.
„ the resistance of each 10a test probe is very low.
„ the measurement is made in 4-wire mode, therefore lead resistance compensation is not necessary.
„ the straight spring loaded test probe, which is thicker, allows a more "rugged" use. the pistol-grip test
probe is used for applications in more confined spaces.
NOtE: at the other end of the leads there are safety terminals 4mm in diameter onto
which spaded lugs (6mm in diameter) are screwed into. these probes can therefore
be used with micro-ohmmeters having either binding posts from 4mm to 6mm in
diameter or safety terminals 4mm in diameter.
cONtENtS
1. INtRODUctION
3