Dishwasher Feedback Section; Canceling A Cycle; Changing A Cycle After Dishwasher Is Started - Kenmore ULTRACLEAN 665.1455 Guide D'utilisation Et D'entretien

Status Indicator Lights
Selecting Cycles and Options
1. To repeat the same cycle and options used on previous cycle, press START/RESUME once to show which selections you have
used. Press START/RESUME again and close the door within 3 seconds to run the cycle. If the door is not closed in time the
dishwasher will beep several times and will not start.
2. To start a new cycle, select the desired options, then press START/RESUME and close the door within 3 seconds to run the cycle.
If the door is not closed in time the dishwasher will beep several times and will not start. Not all options are available for every
cycle. If an invalid option is selected for a given cycle, the lights will flash.
Turning OFF/ON the Sound
Press and hold HIGH TEMP for 3 seconds to toggle sound ON and OFF. The sound will not be deactivated for cycle interruption.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. To cancel selections and/or drain press and hold the START/RESUME button for 3 seconds. If you drain the dishwasher by
selecting CANCEL/DRAIN the word drain will turn on and the time display will show minutes of drain remaining. The drain
will not begin until the door is closed.
3. Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the
dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. See steps in the previous "Canceling A Cycle" section for canceling the current cycle.
2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before
restarting your new cycle.
3. Select new cycles and options.
4. Press START/RESUME.

Dishwasher Feedback Section

The full lit display will glow for wash, drying, sanitized, and complete. It will also display
the estimated remaining time for the cycle in hours and minutes.
The indicator light on the front panel is green when running and off when the cycle
is complete.

Canceling A Cycle

Changing A Cycle After Dishwasher Is Started

19