Machine's Safety Equipment - Husqvarna 324RX-Series Manuel D'utilisation

BOOTS
Wear boots with steel toe-caps and non-slip sole.
CLOTHING
Wear clothes made of a strong fabric and avoid loose
clothing that can catch on twigs and branches. Always wear
heavy, long pants. Do not wear jewellery, shorts sandals or
go barefoot. Secure hair so it is above shoulder level.
FIRST AID KIT
Always have a first aid kit nearby.

Machine's safety equipment

This section describes the machine's safety equipment, its
purpose, and how checks and maintenance should be
carried out to ensure that it operates correctly. See the "What
is what?" section to locate where this equipment is
positioned on your machine.
The life span of the machine can be reduced and the risk of
accidents can increase if machine maintenance is not
carried out correctly and if service and/or repairs are not
carried out professionally. If you need further information
please contact your nearest servicing dealer.
IMPORTANT! All servicing and repair work on the machine
requires special training. This is especially true of the
machine's safety equipment. If your machine fails any of
the checks described below you must contact your service
agent. When you buy any of our products we guarantee the
availability of professional repairs and service. If the
retailer who sells your machine is not a servicing dealer,
ask him for the address of your nearest service agent.
WARNING! Never use a machine with faulty
!
safety equipment. The machine's safety
equipment must be checked and
maintained as described in this section. If
your machine fails any of these checks
contact your service agent to get it
repaired.
Throttle lockout
The throttle lockout is designed to prevent accidental
operation of the throttle control. When you press the lock (A)
(i.e. when you grasp the handle) it releases the throttle
control (B). When you release the handle the throttle control
and the throttle lockout both move back to their original
positions. This movement is controlled by two independent
GENERAL SAFETY PRECAUTIONS
return springs. This arrangement means that the throttle
control is automatically locked at the idle setting.
A
B
Make sure the throttle control is locked at the idle setting
when the throttle lockout is released.
Press the throttle lockout and make sure it returns to its
original position when you release it.
Check that the throttle control and throttle lockout move
freely and that the return springs work properly.
See instructions under the heading Start. Start the machine
and apply full throttle. Release the throttle and check that the
cutting attachment stops and remains at a standstill. If the
cutting attachment rotates with the throttle in the idle position
then the carburettor idle setting must be checked. See
instructions under the heading Maintenance.
–
English 39