Attaching The Sanding Paper; Assembling/Disassembling/Emptying The Dust Collection Box; On/Off Switch; Sanding - Batavia BT-DS003 Mode D'emploi

• Depending on grain size there are
degrees of coarseness. The coarseness
is specified by a number on the back of
the papers. The higher the number is,
the finer the grain.
• It is important to use the right paper for
each job. For rough sanding use grain
sizes up to 80, for soft wood as larch,
pine or spruce use papers from 120 to
150. For dense hardwood as beech or
maple, the grain sizes up to 220 can be
used.

9. Attaching the sanding paper

Choose the sanding paper according to the
material being worked.
Attach the sanding paper to the sanding
9.1
plate (3) and make sure the holes on the
sanding paper fit with the openings on
the base plate. Only this way the sand-
ing dust can be extracted through the
built-in dust removal in the sanding
plate.
Firmly press the sanding paper down on
9.2
the sanding plate.
10. Assembling/Disassembling/
Emptying the dust collection box
Always use the dust collection box (6) when

sanding.

Place the dust collection box onto the
10.1
provided dust collection flange (5).
Push the connection piece into the
flange and turn it clockwise until it locks
into place.
To remove the dust collection box, turn
10.2
the connection piece counter clockwise
and pull it out of the flange. Preferably
clean the dust collection box and the
exhaust connection in the housing after
each use. By doing this the dust collec-
tion box can be easily inserted and
removed.
For emptying the dust collection box,
10.3
just tap out or, if available, clean with
compressed air.
7062852-Delta_Sander_130W-Ma-1805-01.indb 7
All manuals and user guides at all-guides.com

11. ON/OFF switch

After attaching the sanding paper con-
11.1
nect the multi sander to the dust extrac-
tion and to the mains power.
To turn the machine on, set the ON/OFF
11.2
switch (1) to I. To turn the machine off,
set the ON/OFF switch to O.
12. Sanding
• Apply only moderate pressure on the
machine. Too much pressure will lead
to jamming of the mechanism and will
spoil the result. Excessive pressure will
overheat the machine.
• Always select abrasive paper with
coarseness suited the condition of the
surface.
• Use finer papers in the consecutive
sanding until the desired smoothness is
reached. If you desire a very smooth
finish you may slightly moisten the
surface before the last sanding. This
will slightly swell the fibres and allow a
smoother finish.

13. Cleaning and maintenance

• To avoid injury always pull the power
plug before maintaining or cleaning the
machine.
• Clean the machine with a moist cloth.
• If the machine is very dirty use a mild
detergent or soap on the cloth. Other
cleaning agents may contain chemical
substances which may damage the
plastic parts of the machine.
• Do not allow liquids to enter the
machine and do not immerse the
machine in liquids of any kind.
• Repairs, inspections of the interior of
the machine, adjustments and replace-
ment of the carbon brushes may only
be undertaken by a professional. Only
identical replacement parts may be
used! For further information please
contact our customer service
department.
• Always keep the ventilation slots (4)
open and clean. After each use remove
dirt and contaminations with a brush or
blow it out with compressed air.
English
7
01-05-18 12:33