Led Indicator Lights On The Rear Of Subwoofer And Surround Speakers - Samsung HW-Q950A Manuel Complet

4. Check if the LINK LED is solid blue (connection complete).

LED Indicator Lights on the Rear of Subwoofer and Surround Speakers

LED
Blue
Red
Red and blue
NOTE
• If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the STANDBY LED on the rear of the sub-woofer will
turn red after blinking in blue several times.
• If you use a device that uses the same frequency as the Soundbar near the Soundbar, interference may cause some sound interruption.
• The maximum transmission distance of the main unit's wireless signal is about 32.8 ft (10 m), but may vary depending on your operating
environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all
because the wireless signal cannot penetrate metal.
CAUTION
• Wireless receiving antennas are built into the wireless subwoofer and Surround Speakers. Keep the unit away from water and moisture.
• For optimal listening performance, make sure that the area around the wireless subwoofer and the Surround Speakers are clear of any
obstructions.
LINK LED - Blue is On
Status
On
Blinking
On
Blinking
The LINK LED indicator stops blinking and glows a solid blue when a connection
is established between the Soundbar and the Wireless Subwoofer, surround
speakers.
Description
Successfully connected
(normal operation)
Recovering the connection
Standby (with the
Soundbar main unit turned
off)
Connection failed
Malfunction
ENG - 15
Resolution
-
Check if the power cable attached to the main Soundbar
unit is connected properly or wait about 5 minutes.
If blinking persists, try manually connecting the
subwoofer and Surround Speakers. See page 14.
Check if the power cable attached to the main Soundbar
unit is connected properly.
Connect again. See the instructions for manual
connection on page 14.
See the contact information for the Samsung Service
Center in this manual.