Important; General Characteristics - Sacopa OnLED Manuel D'installation Et D'entretien

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be im-
plemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the OnLED Rapid Projector, follow the instructions provided below:
1. VERIFY THE CONTENTS OF THE PACKING:
The following accessories are included inside the box:
• Unit projector
• 1" 1/2 adaptor
• Manual for electrical connection

2. GENERAL CHARACTERISTICS:

This projector has been designed to be used totally submerged in water. It is a Class III electric apparatus with very low
safety voltage (12V with alternating current).
The projector compiles with IPX8 degree of protection (resistance to penetration of dust, solid bodies and humidity) at a
nominal immersion depth of 2 m.
This projector compiles with international safety standards for lights, especially the EN 60598-2-18 standard. LIGHTS
PART 2: SPECIFIC REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND SIMILAR APPLICATIONS.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric components
which have been inserted or handled at locations other than its own premises.
3. INSTALLATION:
• To correctly light a swimming pool we recommend you:
Install a projector in the range OnLED Rapid every 20 m² of water surface.
Note: Recommendation valid for light coloured pools. In darker coloured pools or stainless steel pools we recommend
oversizing the proportion of projectors per m².
• In order to prevent glare, the projectors should be installed so that they face away from the residence or usual view of
the swimming pool.
• In the event that lighting is used in training or competition pools, the projectors should be installed on the sides to
prevent glare on the swimmers.
• The spotlight should not be handled internally under any circumstances as this would lead to losing the guarantee.
• If the OnLED Rapid is mounted on piping, bushing or wall conduits, a siphon should be used to avoid emptying the pool
(see Fig. 1).
• The projector should be fitted 400–700 mm under the surface of the water on one of the pool walls (Fig. 1). It is recom-
mended that sufficient cable be left inside the niche/piping/busing to be able to take the projector out of the water in
order to change the bulb.
4. ASSEMBLY:
There are various options for mounting the OnLED Rapid:
Concrete pools
A) Directly on Ø63 PN-6/10 piping. (Fig. 2a)
Recess required: No / Accessories required: 62395 / Siphonrequired:Yes
Procedure:
1 - An O-ring should be chosen that fits to the piping and placed on the adaptor.
2- Twist the adaptor into the piping.
3- Insert the cable in the piping, ease the projector in and turn 90º clockwise (Fig.5a).
4- Ensure that the logo is uppermost. (Fig. 4).
B) On bushing with G1"1/2 glued to Ø63 piping. (Fig. 2b, 2c)
Recess required:
35418 for Ø63 PN-06 piping
35421 for Ø63 PN-10 piping
Accessories required: No / Siphonrequired:Yes
Procedure:
• Warranty booklet
• Installation and maintenance manual
• Spanner for adaptor
2