Festo CPA VI Serie Notice Simplifiee page 11

CPA..-...-VI-MP-...
2.1 Pin numbering of the multipin plug
The pin numbering of the multipin plug (25-pin Sub-D plug) on
the valve terminal is shown in the diagram below.
(Pin 1 corresponds to address 0, ... Pin 22 corresponds to
address 21)
Recommendation:
In order to connect the type 12 valve terminal, use Festo
multipin sockets and multipin cables. Only then can you comply
with protection class IP 65.
3
Controlling the valve terminal
Always control the valve terminal in a uniform mode. Preferably
with all control signals positive-switching (1-switching) or all
control signals negative-switching (0-switching). Control in
mixed mode is not permitted.
9806NH
11