Troubleshooting - Grandhall B17001050A Manuel De Montage Et D'utilisation

Barbecue électrique
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

.
8
IF THE GRILL FAILS TO PRODUCE ANY HEAT
1.
Be sure there is power to the grill. Turn the control knobs off
and try the following:
Plug cord into properly grounded outlet.
Outlet may be faulty. Try another outlet.
Make sure the grill is on a dedicated outlet. The grill can-
not be used if there is another device plugged into the
outlet.
2.
Control knob(s) may be in 'OFF' position.
Turn Infrared knob to
(see page 6 for more details).
3.
Heating element may need replacing.
Contact your Grand Hall retailer to order replacement par ts
and only use Grand Hall cer tified replacement par ts.
4.
The internal heating element will automatically shut itself off
after the set time limit has been reached.
To reset the internal timer, turn the control knobs to 'OFF'
and unplug the cord from the power outlet. Plug the cord
back in and turn the timer and Infrared knobs on.
5.
The internal heating element will automatically shut itself off
if the internal air temperature of the grill reaches 300
Check to see if the timer knob has reached zero (0). If it
hasn't reached zero (0), open the lid to cool the grill
down. The power should autom atically star t after ap-
proximately 10 minutes (this figure may vary if the grill is
used in hotter climates).
IF THE GRILL COOKS TOO SLOW LY
1.
Always preheat the grill with the lid closed before putting food
into the grill. Do not preheat for more than 15 minutes on the
highest setting.
2.
If it is windy, reposition the grill to reduce its effects.
3.
Infrared knob may be set too low.
Turn infrared knob to
T R O U B L E S H O O T I N G
. Turn timer knob to desired time
o
C.
.
IF THE HEAT ON LIGHT I S OFF
Be sure there is power to the grill.
1.
Control knobs may be in 'OFF' position.
2.
Set Infrared knob to desired setting. Set timer knob to
desired time.
Auto knob has been triggered (internal temperature of grill has
3.
reached 300
o
C).
Do not preheat on the highest setting with the lid closed
for more than 15 minutes. Open the lid to cool the grill
down. The grill should restar t automatically after about 10
minutes.
Heat ON light or heating element may need replacing.
4.
Contact your Grand Hall retailer to order replacement par ts
and only use Grand Hall cer tified replacement par ts.
CIRCUIT BREAKER CONTI NUES TO TRIP
Caused by a power surge
1.
Make sure the control knobs are set to 'OFF' before plug-
ging OR unplugging your grill.
Circuit may be overloaded with appliances.
2.
Disconnect other appliances from the circuit when using
your grill.
Electrical connections may be damp or wet.
3.
Always keep cord dry and off the ground.
Never put the cord or heating element in water or any
liquid.
If the grill is outdoors, do not use it when it is raining.
If the grill is being used in a humid area, it may take a day
or more for electrical circuits to thoroughly dry before the
breaker will reset. This is not a defect of the product.
Electrical cord may be damaged. Never operate your grill if the
4.
cord or plug appears to be damaged.
Contact your Grand Hall retailer to order replacement par ts
and only use Grand Hall cer tified replacement par ts.
IF YOU HAVE EXCESSIVE FLARE- UPS
W HEN COOKING:
The fats and juices dripping from grilled food can cause flare-
1.
ups. To minimise flare-ups try the following:
Trim excess fat from meat before grilling.
Consider choosing leaner cuts of meat for cooking.
Use a lower temperature setting.
Grease and food build up inside your grill and grease recep-
2.
tacle.
Be sure your grill is turned off, unplugged, and completely
cool. Follow the 'Cleaning and Maintenance's teps found
in this manual to clean the grill plate / hot plate, grease
receptacle, and inside of bowl and lid.
8

Publicité

Chapitres

Table des Matières
loading

Table des Matières