Electrolux EWF 128500 W Notice D'utilisation page 16

16 electrolux
To interrupt a programme which is running,
press the button 8: the green pilot light
starts to blink.
To restart the programme from the point at
which it was interrupted, press the button 8
again. If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the red pi-
lot light of the button 8 blinks for 3 times
the message Err is displayed for few sec-
onds.
SELECT THE TIME MANAGER OPTION
BY PRESSING BUTTONS 9
By pressing these buttons repeatedly, the
duration of the washing cycle can be in-
creased or decreased. The icon 7.7 will ap-
pear on the display to indicate the chosen
degree of soil. This option is available only
with Cotton, Synthetic and Delicate pro-
grammes.
Washing cy- Soil
cle Level
icon
Intensive
Normal
Daily
Light
Quick
Super Quick
1)
1) We recommend you to reduce the load sizes (see
Washing programmes table).
Important! The Time Manager cannot be
selected with the programmes
The availability of these soil level icons
change according to the type of fabric as
shown in the following chart.
Fabric
Cottons
95°/90°C X
60°C/50°C X
40°C X
30°C X
Cold X
Synthetics
All manuals and user guides at all-guides.com
Type of fabric
Heavy soiled items
Normal soiled items
Daily soiled items
Slightly soiled items
Very slightly soiled
items
Items used or worn
for a short time
.
Soil Level
X X X X
X X X X
X X X X
X X X X
X X X X
Fabric
60°C/50°C
40°C
30°C
Cold
Delicates
40°C
30°C
Cold
ALTERING AN OPTION OR A RUNNING
PROGRAMME
It is possible to change some options be-
fore the programme carries them out .
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 8 (if you wish to change the Time Man-
ager option, you must cancel the running
programme and make your selection
again).
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
gramme position. Start the new programme
by pressing the button 8 again. The wash-
ing water in the tub will be not emptied out.
INTERRUPTING A PROGRAMME
Press the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
CANCELLING A PROGRAMME
Turn the selector dial to
gramme which is running.
You can select now a new programme.
OPENING THE DOOR
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 8.
X
If the icon 7.10 after a few minutes disap-
X
pears from the display, the door can be
X
opened.
If the icon 7.10 does not go off, this means
X
that the machine is already heating or that
X
the water level is too high. Do not try to
force the door!
Soil Level
X X X
X X X
X X X
X X X
X X X
X X X
X X X
and then to the new pro-
to cancel a pro-
X
X
X
X
X
X
X