Publicité
Les langues disponibles
Les langues disponibles
5.
Determine the distance between each stud, for
example, 12".
6.
Press
and
until the top number on the
screen is set to the distance from the right edge
of one stud to the left edge of the next (e.g., 12")
(Figure
).
U 1
7.
Line up the back of the tool with the right edge of
the last stud that is nailed in (Figure
8.
Press
to start measuring the distance as
you slowly move the tool to the right.
9.
Continue moving the tool to the right until the
bottom number on the screen is 0.00 in (Figure
).
U 3
10.
Press
to stop measuring.
11.
Using a pencil, mark the location where the left
edge of the stud should be nailed into the wall
frame.
12.
Nail the left edge of the stud at the marked
location.
13.
For each remaining stud in the wall frame, repeat
steps 7-12 (Figure
U 4
Measuring an Angle
If you need to determine the angle at which
something is positioned, use the tool to measure that
angle (Figure
).
W
1.
Point the tool's laser (Figure
or object, and not toward anyone's eyes.
2.
Press
(Figure
and display the red laser dot.
3.
Make sure the tool position setting (Figure
is correct for taking the measurement.
All manuals and user guides at all-guides.com
).
U 2
).
) toward a wall
A 1
) to turn the tool on
A 3
C 4
4.
Select
as the measurement type.
• Press
to display the Main Menu
(Figure
E 2
• Press
to select
• Press
to display the Measurement Type
Menu (Figure
• Press the arrow buttons to select
• Press
.
5.
Position the tool at the angle to be measured
(Figure
).
W 1
6.
Press
to take the measurement.
7.
View the angle measurement on the screen
(Figure
).
W 2
Using the Tool as a Level
1.
Point the tool's laser (Figure
or object, and not toward anyone's eyes.
2.
Press
(Figure
and display the red laser dot.
3.
Select
as the measurement type.
• Press
to display the Main Menu
(Figure
E 2
• Press
to select
• Press
to display the Measurement Type
Menu (Figure
• Press the arrow buttons to select
• Press
.
4.
Place the tool in the vertical or horizontal position
on the surface that you want to check is level
)
(Figure
).
V 1
5.
On the tool's screen, view the position of the white
bubble on the vial (Figure
).
.
).
E 3
.
) toward a wall
A 1
) to turn the tool on
A 3
).
.
).
E 3
.
).
V 2
E
19
Publicité
