Rear Panel - Sony LMD-1951MD Instructions D'utilisation

*10 The signal cannot operate with PRESET 7 and 8 (see
page 81).
*11 The signal can only operate with PRESET 1 (see page 81).
*12 The signal can only operate with PRESET 6 (see page 81).

Rear Panel

qa
a Rear cover
Before you connect cables to the terminals, remove the
rear cover.
For how to remove the rear cover, see page 60.
b
/I (Equipotential/Function Earth) terminal
(equipotential) terminal
Connects the equipotential plug.
I (function earth) terminal
Connects the earth cable.
c COMPOSITE IN connector (BNC)
Input connector for composite signals.
d Y/C IN connector (4-pin mini-DIN)
Input connector for Y/C signals.
e G/Y IN connector (BNC)
Input connector for G of RGB signals and component Y
(luminance) signals.
58
Location and Function of Parts and Controls
1
2 3 4 5 6 7 8
qs qd
*13 When a BKM-256DD is installed, the number of the
input connector is increased.
*14 When a BKM-250TG is installed, the signal can be input.
9 0
qf qg qh qj
f B/P
IN connector (BNC)
B
Input connector for B of RGB signals and P
difference) of component signals.
g R/P
IN connector (BNC)
R
Input connector for R of RGB signals and P
difference) of component signals.
h EXT SYNC IN (external sync input) connector
(BNC)
When this unit operates on an external sync signal,
connect the reference signal from a sync generator to
this connector.
To use the external sync signal, press the function button
that EXT SYNC is assigned (F1 button at the factory
setting).
qk
(blue color
B
(red color
R