Gear; Cleaning And Lubrication - Husqvarna 325HE3 Manuel D'utilisation

Oiling the air filter
Always use HUSQVARNA filter oil, art. no. 531 00 92-48.
The filter oil contains a solvent to make it spread evenly
through the filter. You should therefore avoid skin contact.
Put the filter in a plastic bag and pour the filter oil over it.
Knead the plastic bag to distribute the oil. Squeeze the
excess oil out of the filter inside the plastic bag and pour
off the excess before fitting the filter to the machine. Never
use common engine oil. This would drain through the filter
quite quickly and collect in the bottom.

Gear

There is a grease nipple and a plug for filling lubricant on
the gear housing. Use a grease gun to fill with grease.
This should be done after every 60 working hours. Use
Husqvarna's special grease, no. 503 98 96-04.
CAUTION! The gear housing must not be filled
completely with grease. The grease expands as the
machine heats up during operation. If the gear housing
was completely filled with grease it could damage the
seals and lead to leakage of grease.
The grease in the bevel gear does not normally need to
be changed except if repairs are carried out.
20 – English
MAINTENANCE

Cleaning and lubrication

Clean any resin and plant residue from the blades using
Husqvarna cleaning agent (UL22) before and after using
the machine.
Lubricate the blade bars with Husqvarna special grease
(UL 21) before long periods of storage.
IMPORTANT! Use only HUSQVARNA replacement
parts. Use of other brands of replacement parts can
cause damage to your unit or injury to the operator or
others. Your warranty does not cover damage or liability
caused by the use of accessories and/or attachments
not specifically recommended by HUSQVARNA.
1157424-49 Rev.1 2015-05-22