Kohler K-4108 Guide Du Propriétaire page 8

Remote Control Operation (cont.)
NOTE: For features with multiple settings, press the icon to move
the setting one level higher. If the feature is set at the highest level,
pressing the icon will deactivate it or adjust it to a lower setting.
For "seat temp," "front," "rear," "dryer," "wand," and "water
temp" features, see the "Manual Operation" section.
"preset 1" and "preset 2" - Refer to the "User Presets" sections
below.
"stop" - Stops the front wash, rear wash, or deodorizer features.
Press and hold for 3 seconds to turn the remote control off.
"deodorizer" - Activates the deodorizer. To deactivate, press
"stop" icon.
NOTE: Pulsate and oscillate can be activated at the same time.
"oscillate" - Moves the wand in and out while washing. Press the
icon a second time to deactivate the motion.
"pulsate" - Alternates water flow from the wand. Press the icon a
second time to stop the pulsating flow.
"pressure" - Adjusts the force of the water from the wand. There
are five settings.
Setting the User Presets
NOTE: The presets allow two users to save their feature settings.
When "preset 1" or "preset 2" are selected, the saved preferences
will activate.
While seated, adjust the seat features to your preferences.
Press and hold the preset icon for 3 seconds to save activated
features at the current settings.
To change a setting, adjust the front wash, rear wash, or dryer
feature while the preset is in use. Press and hold the preset icon
for 3 seconds to store the new setting to memory.
Using the User Presets
When "preset 1" or "preset 2" is selected when you are seated,
front wash, rear wash, or dryer will operate at your stored
settings.
If the preset icon is pressed while the seat is occupied, the seat
will gradually (approximately 2 minutes) change to the preset
temperature.
Desynchronizing the Remote Control
1194356-5-E 8 Kohler Co.