Ecler IC6CLASS-54 Notice D'utilisation page 5

Note: there are two grommets and two connectors inside the connection box, connected in
parallel to link another speaker if necessary.
5. Reinsert the connection box into the back can of the speaker.
6. Insert the speaker's frame into the hole, taking care that the 3 revolving fasteners remain in the
retracted position
7. Tighten each of the 3 screws accessible from the front of the unit. The revolving fasteners
rotate and at the end of the tightening, the frame is fixed at its final position
8. Using a flat screwdriver, set one of the following taps with the power selector on the front of the
speaker:
Tap #1
Tap #2
Tap #3
Tap #4
Tap #5
Tap #6
9. Test the operation by powering up the sound system.
10. Finally, install the grill on the speaker frame and turn it slightly so that the revolving fasteners of
the frame and the grille are fitted together. During assembly, hold the grate by the edges (not
the perforated, centre part) to avoid damaging it.
5. PAINT
IC6CLASS-54 is ready to be painted and thus can match any cosmetic criteria of the
environment in which it is installed.
Once the installation is complete, the front grill is the only visible part of the unit, simply paint it
to get the desired result. Paint it carefully, avoiding excess paint from clogging the small holes in its
central area.
Connection to a 70V line
16 Ω - 75 W
1,5 W
3,7 W
7,5 W
10 W
15 W
Connection to a 100V line
16 Ω - 75W
3 W
7,5 W
15 W
20 W
30 W
5