Publicité
Les langues disponibles
Les langues disponibles
1. Unscrew the washer (20) and the screw (21) of the tube (17).
2. Insert the tube (17) in the hole of the base (18).
3. Turn over the base so the tube is pointing the floor, place the weight
(19) in the center of the base, place the washer (20) in the center of the
weight and tighten it firmly with the screw (21).
4. Unscrew the vertical slope screw (8) and the motor safety screw (9)
of the motor (11).
5. Place the motor (11) on the extension tube (15).
6. Fix the motor on the extension tube using the screw (9)
7. Use the motor fixing screw (10) making sure that the head of the screw
fits its place and tighten it firmly.
8. Incline the motor and set the slope you want by tightening the screw
(8).
9. Place the back grille (6) on the motor (11) fixing it with appropriate
screws (5)
10. Insert the fan (3) in the motor shaft (7) and tighten it firmly using the
appropriate screw (4)
11. Open the clips of the front grille (1) and place it on the back grille
making sure that the logo is placed horizontally, parallel with the floor.
Find the proper position and fix the front grille on the back grille by
closing the clips.
12. Fix the grilles using the fixing screw of the grilles (2).
ASSEMBLING
15
Publicité
