Operation; Remote Punch Bass - Rockford Fosgate Punch Installation Et Fonctionnement

I
NSTALLATION
2-Channel Wiring
Bridged/Mono Wiring
O
PERATION

REMOTE PUNCH BASS

Mounting and installation
1. Find a location that gives easy access to the remote.
NOTE:You can mount this unit in a variety of ways. Remove the back housing by using a small flat
screwdriver in the slotted hole at the back.The housing can be installed with the mounting tab up
or down, or left off for in panel installation.
2. Route the cable for the remote and connect to the amplifier.
8