Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS (CONT.)
14. Assemble LEFT and RIGHT MIDDLE LEGS, P2L and P2R, together with SPREADER, P4, using (4) SCREWS, H1,
as shown in Figure 7. Note: Hand place screws in all four pre-drilled holes to align panel before tightening. Attach "L"
SUPPORT PANEL, P22, in same manner using (6) SCREWS, H10, as shown.
15. Attach Middle Leg Assembly between assembled sides, P7L and P7R, using (2) BOLTS, H2, and (2) WASHERS, H3,
on each leg, as shown in Figure 7. Note: Velcro will be used as wire harness in future step.
16. Attach LEFT and RIGHT BACK LEGS, P3L and P3R, using (2) BOLTS, H2, and (2) WASHERS, H3, on each leg, as
shown in Figure 7. Note: Hand tighten for now, and then do final tightening with ALLEN WRENCH, T1, once P4 Spreader
is attached in next step.
17. Attach SPREADER, P4, between Legs using (4) SCREWS, H1, as shown in Figure 7.
Note: Hand place screws in all four pre-drilled holes to align panel before tightening.
P2R
P4
P2L
Figure 7
P22
H10
H1
P4 SPREADER MUST BE CENTERED
CORRECTLY ONTO PRE-DRILLED HOLES
IN LEGS BEFORE ATTACHING WITH H1
SCREWS.
H2
H3
CAUTION:
P22
Velcro
Note: Correct location
of Support Panel to Legs
9
Publicité
