Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS (CONT.)
27. Loosely attach NET FRAME FRONT, P18, and NET FRONT BACK, P19, to the Back Side Aprons and Triangle Patch
using (4) BOLTS, H4, and WASHERS, H6, through the eye hole at the bottom of the frames.
28. Attach (2) NET SPACER BARS, P20, between the Front and Back Frames, on either side, by inserting the curved
ends into the frame receptacle as shown in Figure 10 .
29. Drape the NET, P17, over the frame with the longest side, and corner rivets, running side to side. The net will angle
down toward the front. Now remove Bolts loosely attached in Step 27, one at a time, and re-insert Bolt through Corner
Rivets and back through Frame Eye Hole until all four are securely attached. Use Velcro on Net to secure Net to Frame.
H4
H6
H4
Figure 10
FINAL SET-UP & HOW TO PLAY
1. Using two adults, set the unit in a suitable location in your game room.
2. Plug in the AC Power Adapter (DO NOT use batteries with adapter), or install four (4) "AA"
batteries (not included), into the backside of the Electronic Scorer, P14
3. Turn the power switch to the ON position.
4. When all "zeroes" are showing on the score board, press the reset button on the front of the
unit. You are now ready to play.
5. Each player rolls six (6) balls per game trying to reach the highest score. If a ball is rolled
and it doesn't score, you may roll that ball again. The player with the highest score wins.
6. After both players have rolled their six balls, press the Reset Button to play again.
7. Turn the power OFF when not in use.
CAUTION: DO NOT THROW the ball at the target board as this may cause damage to the
game. The correct and safe way is to always ROLL the ball along the runway.
P19
Frame
Back
(Smaller)
P17
Net
P20
Spacer Bars
P18
Frame
Front
(Larger)
H6
H4
12
Publicité
