Hathaway HOT SHOT Instructions D'assemblage page 5

ASSEMBLY INSTRUCTIONS
1. Find a clean, level place to begin the assembly of your game. We recommend building the unit on the shipping carton to
protect the parts during assembly. Note: The two main units are assembled upside down then turned over for final assembly.
2. Attach the SUPPORT PANEL, P21, to the FRONT BOTTOM PANEL, P10, using (3) SCREWS, H8, through the two
outer holes as shown in Figure 1. Note: The P10 panel and P21 support panel both have pre-drilled holes for screws.
Figure 1
3. Place the LEFT FRONT SIDE APRON, P6L, and RIGHT FRONT SIDE APRON, P6R, upside down and approx. 2 feet
apart, as shown in Figure 2.
4. Insert FRONT TOP PANEL, P9, with finished white side down, into lower grooves of SIDE APRONS, P6L and P6R.
Make sure the end of P9 with the cutouts is on the same end as gear hinge as shown in Figure 2. Slide P9 forward until
the end with cutouts is flush with SIDE APRON ends above gear hinges. With help from another adult, hold this assembly
firmly and attach pieces together using (2) SCREWS, H1, and pre-drilled holes on each side.
5. Attach FRONT END APRON, P5, with groove facing in, using (2) SCREWS, H1, and pre-drilled holes on each side.
Note: Don't tighten screws all the way until you complete Step 6. This will make it easier to get P10 into P5 groove.
6. Insert FRONT BOTTOM PANEL, P10, with unfinished side up, into upper grooves of SIDE APRONS, P6L and P6R.
Slide P10 forward until the end is flush with SIDE APRON ends above gear hinges, even with panel P9. Tighten P5 Screws.
Figure 2
P21
P5
H1
P6L
H1
Note: Location
of gear hinge
H8
P10
P6R
Note: This unit is assembled
upside down.
White
Side Down
Unfinished
Side Up
P9
Note: Location
of these cutouts
Unfinished Side Up
Black Side Down
Note: Location
of gear hinge
Slide both
panels in grooves
P10
5